Fidelis Network Collector SA Rev-1 Series, Quick Start Manual

Page: 3 / 9

QUICK START GUIDE
Fidelis Network® Collector SA
www.fidelissecurity.com
©Fidelis Cybersecurity
3
Collector Setup Checklist
Check Fidelis Network Sensor – Appliance Requirements
Appropriate rack space, power, and cooling ( Appendix B )
Rack tools, rails, and connectors
Keyboard and video monitor / KVM switch for temporary appliance setup
Power cables — two per appliance, appropriate for power source and region
Ethernet cables (cat5) for Admin and iLO ports ( Section 3 )
Network switches with enough physical ports ( Section 4 )
Logical network information: IP addresses, hostnames ( Section 5 , Appendix A )
For Fidelis Network Software version 9.0.5 and later, the appliance system type ( Appendix C )
3. Collector: Network Port and Cabling Requirements
Each component must be connected to the various networks with appropriate cables. The tables
below describe the physical connection and cable type associated with each port.
Collector SA Appliance
Port Label Physical Connection Type (default) Cable Type
Admin GbE RJ45 (copper) Cat 5 patch cable
iLO GbE RJ45 (copper) Cat 5 patch cable
Figure 3: Network Port Assignments — Collector SA (Rev-I)