7.
Connect the Phoenix™ power connector
from the Power Harness at into its mating
connector on the TD module in each
position.
8.
Install loaded TTM onto truss with
appropriate Cheeseborough clamps.
Reconfiguring Front Connectors
1.
Unscrew and remove the upper positioning and
holding brackets by removing the 7 retaining screws.
Note that the screw that protrudes through the hinge
bracket is slightly longer than the others.
2.
Slightly loosen the 4 screws holding the bottom mounting plate to release the
modular connector plates.
3.
Replace and rearrange connector plates as needed,
taking care to orient the chamfered edges towards
the front of the enclosure.
4.
Replace and the upper positioning bracket using two screws as
shown.
5.
Tighten down the screws which hold the lower holding bracket.
6.
Replace the upper holding bracket and tighten all
screws.
