Figure 4 TTM Open, Bottom
PowerCON TRUE1 Connector
– AC power entry for the unit. This connector mates with a standard
PowerCON AC plug to receive input power with a flexible voltage range of 100 to 240 VAC.
Power Harness with (6 each)
Phoenix™ Power Connectors
– The TTM comes standard with a 6‐
position wiring harness. This
harness receives its power from the integrated power supply.
Connector Position Blanking Plates
– These plates fill unused connector space in the front of the unit.
I/O Connector Positions
– Input and Output connectors to the TD‐Units are provisioned here.
Rear Connector Plates
– The unit can be equipped with up to 4 I/O connectors in the rear, allowing for
easy bidirectional connection. Please note that these plates are differently sized and not interchangeable
with the front I/O connector plates.
Enclosure Latch
– The unit is securely closed screwing the two captive screws in the latch bracket into
holes on the opposite enclosure half.
Hinge
– The reinforced aluminum hinges allow the unit to smoothly swing open for easy service and
reconfiguration, and swing closed for a compact profile during use.
Ventilation Fan
– The unit comes equipped with a quiet running 50 mm fan to remove any exceess
heated air inside the enclosure.
Swivel bracket
–
Attached to the enclosure is a swivelable mounting bracket. Truss clamps are mounted
in the two slots. The swivel position of the bracket can be adjusted by loosening the thumbscrews, then
squeezing the two sides together to free the positioning pins. While squeezing, rotate the bracket into the
desired position, then let go and tighten the thumbscrews. Optionally, wing nuts can be screwed onto the
thumbscrews and jammed against the mounting bracket threads to provide vibration resistance.
8
17
8
9
10
11
12
13
14
15
16
17
