Installing TD Modules
1.
Orient the TD Series module with the rear
(power side) facing the rear of the TTM
2.
Align the large opening of the keyhole on the
bottom to the TD module with the pressed
studs on the Mounting Tray
3.
Lower the TD module over the studs until the
module is flat on the tray and slide to the front
of the Mounting Tray until the module stops
4.
Repeat steps 1‐3 until all desired modules are
installed.
5.
Lower the Retention Bar flat on the tray so that
it is on the rear (power) side of the TD modules
and straddles the threaded standoffs
6.
Push the Retention Bar forward until it is secure
against the TD modules, there should only be a
tiny shift as it tightens against the unit. Tighten
the Retention Screws. Repeat steps 5 and 6 for
the three modules on the other half of the
enclosure.
