Fiberplex SFP-BHDVXC-0000-L, User Manual

Page: 16 / 24

Addr Field Name Registry Name Description Default
Value
(hex) Default
Value
(dec)

Reclocker Rate: Indicates whether the reclocker is processing SD or HD/3G data rates.

Reclocker Bypass: When the Bypass bit set to ‘1’, it forces the device to output the data without reclocking it. If the Bypass bit is set
to ‘0’, the device automatically bypasses the reclocking function when the device is an unlocked condition or the detected rate is a
rate which the device does not support. Note that when the Bypass input is set to ‘1’, Lock detect will remain low.

Reclocker Lock: When the Lock bit egal ‘1’, it indicates that data is being received and the PLL is locked. Note that when the Bypass
bit is set to ‘1’, Lock detect will remain ‘0’.
121‐123 Vendor Specific Vendor Specific Reserved XXh...
124‡ Vendor Specific Advanced Status/Control 2
RX Channel See below for bit definition XXh
MSB LSB
b7 b6 b5 b4 b3 b2 b1 b0
r r/w r r r r r r
NA NA NA NA NA Reclocker
Bypass
1=Bypass
0=Auto‐Bypass (default)
Reclocker Lock
1=Lock Detect 0=Not
Lock
Autosleep 3
1=Enable Autosleep
(default)
0=Disable A utosleep
‘0’ ‘0’ ‘0’ ‘0’ ‘0’ ‘0’ ‘X’ ‘1’

Reclocker Bypass: When the Bypass bit set to ‘1’, it forces the device to output the data without reclocking it. If the Bypass bit is set
to ‘0’, the device automatically bypasses the reclocking function when the device is an unlocked condition or the detected rate is a
rate which the device does not support. Note that when the Bypass input is set to ‘1’, Lock detect will remain low.

Reclocker Lock: When the Lock bit egal ‘1’, it indicates that data is being received and the PLL is locked. Note that when the Bypass
bit is set to ‘1’, Lock detect will remain ‘0’.

Autosleep: If the Autosleep bit is set to ‘1’, the SFP equalizer goes into a power save mode when no signal is detected. The equalizer
power on again once an input is detected. The Autosleep functionality can be turned off by setting Autosleep bit to ‘0’.
122‐127 Vendor Specific Vendor Specific Reserved XXh…
Notes:
1. The values with XXh are either determined during manufacturing or depend on SFP state
2. Address 95 contains the checksum for byte 64‐94
3. Autosleep enables\disables the Save Mode
†: Standard Only ‡: Reclcocker Only