Fiberfab Aztec 7, Assembly Manual

Page: 89 / 140

TAIL SECTION
Tools Required Drill
¼ inch Drill Bit
1/16 inch Drill Bit
3 inch Hole Saw
Jigsaw
Tape
Phillips Screwdriver
Socket Set
Carbide Router Bit
40 and 80 Grit Sandpaper
Assorted Files
Parts Required
Ff #Z736 Taillights
Ff #Z737 Red Side Marker Lights
Ff #Z738 Four Light Brackets
Bolt Kit #29
Bolt Kit #30
Refer to Figures 111 through 118
To cut the louver holes open, drill a ¼ inch hole about 1/6 inch away from the scribe line. Use a carbide router bit
to cut the holes open along the scribe lines. File and sand smooth and straighten the edges cut. Figure 111 shows louvers
being but open.
Measure and mark the rear panel for the taillight assemblies using dimensions given in Figure 112. Cut the
openings with a jigsaw.
Figure 111 Tail Louvers – Cut Recessed Lines Sand to Scribe