Fiberfab Aztec 7, Assembly Manual

Page: 31 / 140

Courtesy Lights
Tools Required
Electric Drill
4 inch Drill Bit
Tape Measure
2 – 7/16 inch Wrenches
Parts Required
Ff #Z777 Courtesy Light Plates
Ff #Z758 Courtesy Lights
Bolt Kit #4
To install courtesy lights, position mounting plate 4 inches in from each end of the underside of the dash flange,
with the hole for the light towards the firewall at the front of the main body. Allow ½ inch of fiberglass from the edge of the
flange to the edge of the bolt holes as shown in Figure 32B. Use the plate as a template to scribe mounting holes on the
underside of the dash flange and drill using a ¼ inch drill bit. Bolt the plate to the dash flange attaching the ground wire
from the light to one of the bolts according to the wiring diagram.
Insure the courtesy light is put into the bracket with the bulb facing downwards. Connect the wiring according to
the wiring diagram.
Figure 32B Installing Courtesy Light