FHM WC8-PRO, Operations & Parts Manual

Page: 13 / 27

Farmer-Helper WC PRO Chipper 13 Revision 9/22/16
Blades Dull Reverse/Replace
PROBLEM: Feed Roll Clutch Kicking in and out of gear
Possible Causes Solution
Blades Dull Reverse/Replace
Material jammed in chute Release feed roll clutch and
remove material by pulling out
of chute, trim forks if necessary
PROBLEM: Chip Deflector Plugging; Chips too long or Stringy
Possible Causes Solution
Blades Dull Reverse/Replace
Bed Blade Rounded Reverse/Replace
Bed Blade not adjusted properly Adjust to Tolerance Level
Flywheel Turning to Slowly Ensure PTO speed 540 RPM
PROBLEM: Material Won’t Feed
Possible Causes Solution
Feed Roll Slide Dirty or Dry Clean & Lubricate
Fork in Material too wide Remove Material and trim fork
Feed Roll Gear Box Loose Tighten Feed RollGearBox Belt
FeedRoll TensionSprings Stretched ReplaceFeedRollTensionSpring
13.PARTS AND FASTENERS
Your chipper is designed for ease of maintenance. Replacement parts are
available from Betst Power Equipment at 1-541-895-3083 or
Support@Betstco.com Check the parts list for specification. Note: All
bolts on the flywheel, blades, and bed blade are grade 8 specifications.
All other bolts are grade 2 or 5.