FHM WC8-PRO, Operations & Parts Manual

Page: 7 / 27

Farmer-Helper WC PRO Chipper 7 Revision 9/22/16
PTO driveshaft should consist of a PTO master shield, integral driveshaft
shield, and a chipper input connection shield.
1. Follow all chipper and tractor instruction labels and manuals. The
chipper should be used only with the tractor’s PTO master shield in
place.
2. Specify and test an integral driveshaft shield with end cones which
will overlap, but not interfere with the PTO master shield or chipper
input connection shield.
3. A chipper input connection shield should be used in addition to the
integral driveshaft shield, in order to guard the shaft coupling and any
torque limiting device installed on the driveshaft.
4. Check that all routine maintenance of the driveshaft can be done
without removal of the shields.
5. SAFETY INSTRUCTIONS
Do not attempt to operate the chipper until you have read and understood
this manual.
Always keep guards and chipper shields properly installed while
operating the chipper.
Keep the decals in place and verify they are understandable. New labels
can be ordered from Betst Power Equipment upon request. If your chipper
is repainted, be sure the labels and decals remain visible.
Never leave the chipper running unattended.
Do not attempt alterations, repairs or adjustments while chipper head is
turning. Always disconnect the PTO and stop the tractor motor, then put
keys in your pocket.
Keep hands, feet and other extremities out of and away from
the hopper. When checking blades or adjusting the cutting bar,
EXERCISE EXTREME CAUTION! If accidentally rotated,
the flywheel can contain enough residual energy to cause
serious injury.
Point the discharge chute away from doorways, sidewalks, or any areas
where your view is obstructed.
The chute should be pointed downwind when possible.