27
MAINTENANCE
Installing New Polyurethane Wear Edges
NOTICE!
All nuts and bolts must be installed using proper torque specifications (refer to Bolt
Torque Specifications).
NOTICE!
Improper installation of edges will result in damage to plowing surface and premature
wearing of edges.
1. Park prime mover on a firm, level surface with blade properly attached.
2. Lower the blades cutting edge onto a sturdy wood or metal blocking, positioned under the pivoting
assembly, to safely hold the wear edge 6 to 8 inches above the level surface.
3. Place primer mover in “Park” and engage parking brake.
4. Remove and retain all nuts and bolts but the ones at each end of the wear edge.
5. Support one end of the wear edge, remove the nut and bolt, then lower it to the level surface.
6. Support the other end, remove the nut and bolt and lower to the level surface.
7. Store wear edges and all nuts and bolts for possible future use.
8. Support one end of the new wear edge and install with a new nut and bolt.
9. Support the other end and install a new nut and bolt
10. Install all new nuts and bolts.
11. Repeat steps 4-10 for other wear edge.
12. Install center rubber wear edge and plates with new nuts and bolts.
NOTICE!
When installing nuts and bolts on center rubber wear edge, DO NOT tighten to
specified torque. Tighten until the retaining plate has slightly compressed the rubber.
Summary of Contents for V-Snow Blade
