fetra 2122, Operation Manual

Page: 30 / 100

30
Transport equipment
2.2.3. Press the draw-bar (G110) down, take away the spring which fixes the Spring Cap
(301).
2.2.4. Put the control handle (G117) to then raise position, the raise the lever plate
(319) with the pin and insert the adjusting bolt (G103) into the front slot of the lever plate
(319). Note: keep the adjusting nut (G104) underneath the lever plate.
2.2.5. Use a hammer to tap another elastic pin (G106) into the axle with hole (G105) The
draw-bar is now assembled to the pump.
3. To adjust release device
On the draw-bar of this pallet truck, you can find the control handle (G117) which can be
regulated in three positions:
Raise: handle down
Drive: handle in center
Lower: handle up, the lever moves back to the drive position when released.
If, however, they have been changed, you can adjust them according to the following
instructions:
3.1. If the forks elevate while pumping in the drive position, turn the adjusting nut (G104)
on the adjusting bolt (G103) or screw (318) clockwise until pumping action does not raise
the forks and the drive position functions properly.
3.2. If the forks descend while pumping in the drive position, turn the nut(104) or
screw(318) counter-clockwise until the forks do not lower.
3.3. If the forks do not descend when the control handle (117) is in the lower position,
turn the nut(104) or screw (318) clockwise until raising the control handle(117) lowers the
forks. Then check the drive position according to item 3.1 and 3.2 to be sure the nut (104)
and screw(318) is in the proper position.
3.4. If the forks do not elevate while pumping in the raise position, turn the nut (104) or
screw (318) counter-clockwise until the forks elevate while pumping in the raise position.
Then check the lower and drive position according to item 3.1, 3.2 and 3.3.