fetra 2122, Operation Manual

Page: 38 / 100

38
Transport equipment
6.4. Lubrication
All bearings and shafts are provided with long-life grease at the factory. You only need
add long-life grease at monthly intervals or after each time the lubrication points of the
truck are cleaned thoroughly.
6.5. Battery replacement
A) Remove the screw (238-7) and the battery cover (238-8).
B) Use 4 new “AA” batteries (238-9) to replace the old ones.
C) Replace the battery cover (238-8) and tighten the screw (238-7) securely.
6.6. Maintenance of display unit
The weighing system meets up to the protection class IP65. This means that dust or mois-
ture (rain or water beam from all sides), will not influence the operation of the electronics.
However, high-pressure cleansing in combination with warm water or chemical cleansers
will lead to the entry of moisture and therefore negatively influence the operation of the
system.
7. Guide to safe operation
To pull the truck, always move the control handle into the drive position. This makes
the draw-bar easier to move and depressurizes the pump section of the hydraulics. This
preserves the hydraulic seals and the valve components.
Operator should read all warning signs and instructions here and on the pallet truck
before using this truck with scale.
Do not operate a pallet truck with scale unless you are familiar with it and have been
trained or authorized to do so.
Do not operate a pallet truck unless you have checked its condition. Give special atten-
tion to the wheels (227or 234, 310), the draw-bar unit, the fork unit, the lever plate (319),
etc.
Do not use on a slopping ground.
Do not take any people on the pallet truck when moving.