Fetco CBS-2031ee, User Manual

Page: 11 / 28

11
Address Description Range Default Comment
60
and
61
Left Brew Valve
Flow Rate
Right Brew Valve
Flow Rate
CBS-2031ee/2032ee 0.35 – 2.24
If #59 is LTR
or
0.09 – 0.59
If #59 is GAL
1.48
0.39
CBS-2041ee/2042ee 0.09 – 0.59
If #59 is GAL
or
0.35 – 2.24
If #59 is LTR
0.40
1.51
Use this to compensate for minor discrepancies in
actual volume versus programmed volume. Set
lower to increase volume, higher to decrease
volume. The following formula can be used to
determine the correct setting:
ACTUAL VOLUME
PROGRAMMED VOLUME
X
CURRENT
SETTING
=
NEW
SETTING
64 Keypad Test 0 - 1 0 Tests function of control panel switches.
Starting at the batch buttons, press each button
that is lit. The display will show the name of the
switch being pressed and the switch light will go
out. Brew switches are named S1, S2, S3, etc.
The left STOP switch must be pressed last, as
this will exit the test.
65 Relay Test 0 Tests the individual relays that control various
components.
0 - Skip relay test.
To start Relay Test, press top batch button –
display will read OFF.
Press power switch – display will read ON.
Press
STOP to continue.
Use the batch buttons to turn each component
ON and OFF.
Address Description
90 Left or Single Brew Valve
91 Right Brew Valve
95 Fill Valve
96 Heater
(To protect the heaters, this test will work only if the tank is full.)
Press STOP to go back to address 65.
Press the lower batch button to exit the Relay Test.
67 Factory Use Only – Do not use.
Important! To save your changes, press and hold STOP until the display reads STO to exit programming
mode and return to operating mode.
Warning: During these
tests, hot water may
be dispensed from
the valve being tested.