Festool CSC SYS 50 EBI, Original Instructions Manual

Page: 41 / 254

The hex key cannot be
inserted into the open­
ing on the type plate.
The saw blade is not in the
parked position.
Move the saw blade to the parked position with
the control module (see section 9.8 ).
The cutting angle does
not match the indica­
tion on the display.
Cutting angle shifted. Calibrate the cutting angle (see section 9.7 ).
The cutting height does
not match the indica­
tion on the display.
Cutting height shifted. Calibrate the cutting height (see section 9.5 ).
Reference movement
failed
An area cannot be reached.
End stops dirty.
Clean the end stops (see section 12.6 ).
The sliding table and
plate are not at the
same height.
Sliding table height shifted. Adjust the height of the sliding table (see sec­
tion 12.2 ).
The extension table
and plate are not at the
same height.
Extension table height shif­
ted.
Adjust the extension table height (see sec­
tion 12.1 ).
The sliding table can
no longer be moved
fully into both posi­
tions.
Maximum lift shifted. Adjust the maximum sliding table lift (see sec­
tion 12.3 ).
The sliding table is dif­
ficult to move.
Dirty tracks. Clean the tracks with a cloth (see section 12.4 ).
Ball bearings dirty. Contact an authorised service workshop or the
manufacturer.
Splintering during saw­
ing
The parallel side fence for
free cuts has shifted.
Alignin the parallel side fence to the saw blade
(see section 12.7 ).
Motor runs with re­
duced power
Motor temperature too high.
Speed has been reduced to
allow the ventilator to cool
the motor quickly.
The power tool starts up again automatically
once the motor has cooled sufficiently.
Only continue working once cooling down has
concluded.
English
41