Festool C 12 Li, Instruction Manual

Page: 13 / 40

13
Attaching/Detaching eccentric attachment DD-ES
The eccentric attachment is attached/detached in the
same way as the angle attachment (Section "Angle
attachment DD-AS").
Attaching/Detaching the chuck
The chuck is secured to the shaft [8-1] of the eccen-
tric attachment and the drill spindle on the machine
in the same way.
Tool holder in the drill spindle
Bits can be inserted directly in the hexagon socket
holder on the drill spindle
[9-1] to shorten and re-
duce the weight of the machine.
Working with the machine
Consider the pictures on the fold-out page.
Switch on/off
The switch [1-9] is an on/off switch (press = ON, re-
lease = OFF).
L
The speed of the machine depends on how far the
ON/OFF switch is pressed in.
L
When the ON/OFF switch is released, the working
spindle (chuck) stops immediately.
The LED lamp [1-3] lights up when the on/off switch
[1-9] is pressed and lights up the working area.
Bit store
Bits or bit holders are inserted sideways into the bit
store
[1-2] .
Acoustic warning signal
Acoustic warning signals sound and the machine
switches off in the following operating states:
DD-ES
1 - 8
9-1
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stres.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.
peep ― ―
peep peep ―
peep peep peep