Festo SDE1 Series, Operating Instructions Manual

Page: 54 / 64

SDE1−...
Festo SDE1−... 0511e English
54
7 Operation
Warning
Excessive internal heat will damage the SDE1−...
S
Avoid high cycle frequencies with large pressure amplitudes.
Otherwise the permitted maximum temperatures of the materials used will
be exceeded.
Reset the SDE1−... to the factory setting
(also if the security code cannot be found)
Please note
The current settings will be lost after a reset to the factory setting.
S
If necessary, make a note of these settings before a reset.
In order to reset the SDE1−... to the factory setting:
1. Switch off the operating voltage.
2. Press all three setting controls simultaneously (UP/DOWN button and EDIT
button) and switch the operating voltage on again.
8 Care and maintenance
Cleaning:
S
Switch off the following sources of energy before cleaning the exterior of the
unit:
operating voltage
compressed air/vacuum.
S
If necessary, clean the exterior of the SDE1−...
Soap suds (max. +60 °C), petroleum ether and all non−abrasive cleaning agents
may be used.