5
Conversion and maintenance
Festo – P.BE-MPA-EN – 1309f – English
103
5.3.4
Replacing valves or cover plates
The sub-bases of the MPA-S valve terminal with multi-pin plug connection support actu-
ation of one or two solenoid coils per valve position, dependent on the built-in MPA elec-
tronics module (
Tab. 5.4).
Dismantling
Proceed as follows:
•
Use a screwdriver with a narrow blade to loosen the mounting screws and remove the component
from the sub-bases (
Fig. 5.1).
Fig. 5.1
Removing valves or cover plates
Mounting
Proceed as follows:
1. Check the seal for damage.
2. Replace seals if they are damaged.
3. Make sure that the cord seal between sub-base and component is in the correct position: The cord
seal must sit in the cut-out of the component.
Summary of Contents for MPA-S
Page 165: ...C Glossary Festo P BE MPA EN 1309f English 165 C Glossary...
Page 168: ...C Glossary 168 Festo P BE MPA EN 1309f English...
Page 172: ...MPA S 172 Festo P BE MPA EN 1309f English...
Page 173: ......
