1 Shield sleeve
Fig. 21 Shared shield support of all cable shields (example)
Option 2: The outside shield of the motor cable is placed separately over a large area below the shield
clamp on the front of the CMMT-AS. The inside shields are placed separately on the intended PE pin of
the connection [X6B].
1 Inside shield placed separately
2 Inside shield placed separately
3 Shield sleeve
Fig. 22 Separate shield support of all cable shields (example)
•
Make unshielded cable ends as short as possible.
Mounting the shield clamp
The lower area of the front of the housing serves as a shield support surface. The shield support sur-
face, together with the shield clamp, permits large surface support of the motor cable shield.
1. Press the shield of the motor cable or the conducting shield end sleeve of the motor cable with the
shield clamp onto the shield support surface of the housing
è
Fig.23.
Installation
64
Festo — CMMT-AS-C2/C4-3A-... — 2018-02
