MACHINES AND
ACCESSORIES
Page 14 of 29
2. Install the vacuum (B) on the support
base (
3. Figure 8), tightening the 4 fastening
screws using an hex wrench.
Figure 8– Mounting the vacuum on the
base.
4. Position the exhaust manifold (L) onto the
body of the vacuum (Figure 10), making
sure to fit the gasket (Figure 9) and
secure it with the four screws, washers
and nuts.
Figure 9 - Mounting the gasket.
Figure 10 – Mounting the exhaust
manifold.
5. Attach the supports (F) to the support base, and then attach the body of the conveyor
(C) to the upper end of the supports
fervi.com
