6
INSTALLATION
SAFETY RULES
The following safety rules must be followed carefully in order to prevent injury to the operator and damage to the
machine .
• Machine installation must be carried out according to the applicable national regulations
• This installer manual, the user manual and the wiring diagrams are an integral part of the machine . They must be
kept together with care and be available to operators for reference whenever necessary .
• Failure to comply with the instructions in this manual and inadequate installation of the air conditioner can void the
warranty . The Manufacturer declines any liability for direct and/or indirect damage due to incorrect installation .
• Extraordinary maintenance must be carried out by specialised and qualified personnel .
• During installation, work in a clean and uncluttered place .
• Never touch the moving parts or place anything between them .
• Before turning the air conditioner on, check the integrity and safety of the various components and the entire
system .
• Carefully carry out routine maintenance .
• If replacing parts, always ask for original spare parts . Otherwise, the warranty is void .
• Do not remove or tamper with the safety devices .
• Disconnect the power before carrying out any work on the machine .
• Do not place anything on top of the units .
• Do not drop or put anything in the fan protection grilles .
• The surface of the coil is sharp . Do not touch it without protection .
• Carefully read the labels on the machine, never cover them; replace them if damaged .
• Do not use the machine in an explosive atmosphere .
• The power supply line must be equipped with an approved earth .
• If the power cable is damaged, have it replaced by an authorised technician .
• The storage temperature must be between -25°C and 55°C .
• In case of fire, use a powder extinguisher . Do not use water .
• In case of machine faults, make sure they are not due to a lack of routine maintenance . Otherwise, request the
assistance of a specialised technician .
• Extraordinary maintenance must be carried out by specialised and qualified personnel .
• Due to the presence of materials subject to regulations and which must be recycled or disposed of at special
centres, the machine must not be discarded during scrapping .
• Do not wash the machine with jets of water, steam or corrosive substances .
The Manufacturer, with its assistance network, is in any case available to ensure prompt and careful technical
support and all that may be useful for best operation and to obtain maximum efficiency .
