Not for
Reproduction
7
(S/N: 2016098451 & Above) Deck Lift Lock Lever Lockout Plate
A
This position will allow
the mower deck to lock
in the TRANSPORT
position when raised.
LOCK
This position will allow
the mower deck to be
raised and lowered
without locking in the
TRANSPORT position
when raised.
UNLOCK
Operation
Before First Time Operation
• Be sure to read all information in the Safety and Operation
sections before attempting to operate this tractor and
mower.
• Become familiar with all of the controls and how to stop the
unit.
• Drive in an open area without mowing to become
accustomed to the unit.
WARNING
• Never operate on slopes greater than 15°.
• Select slow ground speed before driving onto a slope.
Use extra caution when operating on slopes with a
rear-mounted grass catcher.
• Mow across the face of slopes, not up and down, use
caution when changing direction on slopes and do NOT
start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator’s position for any reason,
engage the parking brake, disengage the PTO, stop the
engine and remove the key.
• To reduce fire hazard, keep the engine, rider and mower
free of grass, leaves and excess grease. Do NOT stop or
park rider over dry leaves, grass or combustible materials.
• Fuel is highly flammable and must be handled with care.
Never fill the tank when the engine is still hot from recent
operation. Do NOT allow open flame, smoking or matches
in the area. Avoid over-filling and wipe up any spills.
WARNING
Do NOT load this zero-turn rider on a trailer or truck using two
separate ramps. Only use a single ramp that is at least one
foot wider than the width of the rear wheels of this rider. This
rider has a zero turning radius and the rear wheels could fall
off the ramps, or the rider could tip over injuring the operator
or bystanders.
Checks Before Starting
• Check that the crankcase is filled to the full mark on the
engine oil dipstick. If necessary, add oil through the engine
oil fill. See the engine Operator’s manual for instructions,
engine oil dipstick location and oil recommendations.
• Check the radiator fluid level. See engine operator's manual
for instructions.
• Check the hydraulic oil level.
• Make sure all nuts, bolts, screws and pins are in place and
tight.
• Adjust the seat position and make certain you can reach all
controls from the operator's position.
• Fill the fuel tanks with fresh fuel. Refer to engine manual
for fuel recommendations.
Priming the Fuel System
Priming the fuel system fills the fuel filters and removes any air
bubbles from the fuel system. This must be performed before
the first use, after any fuel maintenance or if the fuel system is
run dry.
16
