65
Rev. 1.1
T250A-T320A
TRANSPORT AND INSTALLATION
4.17
04-Collegamento cimatrice (TP-TM)
IN
OUT
1
1
1
1
B
A
C
4.7.3 Cutter bar connection
1)
Raise the cutter bar using a lifting device (for the location of the lifting points, consult the relevant use and maintenance
manual)
2)
Bring the cutter bar the arm end plate.
3)
Secure the cutter bar with the four screws (
1
) and their washers.
4)
Switch off the engine, apply the parking brake and remove the ignition key from the dashboard.
5)
Make sure that there is no pressure inside the hydraulic system.
6)
Connect the hose (
A
) for the take ‘IN’ and the hose (
B
) for the let ‘OUT’ and the hose (
C
) for the discharge.
7)
To disconnect the cutter bar, proceed in inverse order.
Hydraulic hose
identification code
A
2 YELLOW bands
B
1 YELLOW band
Summary of Contents for T250A right
