Use
23
Clamping the sandpaper
This chapter explains how to attach sandpaper to the square sanding plate. The
square sanding plate is the only one of the three sanding plates that has clamping
bars for clamping sandpaper.
1. Punch holes into the sandpaper for the dust extraction.
18
2
21
20
19
10
18
Front clamping bar
19
Lateral limiter, 2×
20
Clamping lever, 2×
21
Sandpaper (not included)
22
Rear clamping bar
(not shown)
2. Unhook the front clamping bar
18
. To
unhook the front clamping bar, lift the
clamping levers
20
on both sides of the
product and guide the front clamping bar
over the lateral limiters
19
(see
Fig. 10
).
3. Slide the front end of the sandpaper
21
under the front clamping bar.
4. To fix the front end of the sandpaper,
hook the front clamping bar back into
place.
5. Stretch the sandpaper tightly over the
square sanding plate
2
and clamp the
rear end of the sandpaper under the
rear clamping bar
22
.
The sandpaper is now clamped.
Switching on and off
12
11
− To switch the product on, press the
on/off switch
12
on the side marked
with the symbol “I” (see
Fig. 11
).
− To switch the product off, press the
on/off switch on the side marked with
the symbol “0”.
