92 of 120
MVA 02 rev 5 - December 2017
3.- Fit the bush into the hole in the pulley, taking
care to align the threaded half-holes on the pulley
with the unthreaded half-holes on the bush (Photo
32). There may be 2 or 3 of these holes (Fig. 10-5),
as can also be seen in Chart 9.1, depending on
pulley size.
Fig. 10-5 Pulley holes
4.- Screw in the grubscrews by hand without fully
tightening them (Photo 33).
Photo 33
5.- Check that the shaft surface is totally clean, and
insert the fixing spline into its slot (Photo 34).
Photo 34