© Ferno Australia / 00425-V1 / Aug 2018
8
INSTRUCTIONS FOR USE
3.3 IndustriPOD® Assembly
For safety, this operation should be performed by two people.
1. Stand the IndustriPOD® upright with legs together (Figure 1).
2. Extend leg lengths to achieve the desired Head height.
3. To extend legs:
a.
Remove the leg pins from each leg by depressing the pin
release button at the head of the pin (Figure 2).
b.
When legs are extended to desired height, align the holes
on individual leg sections and re-insert the leg pins.
4. Double check all leg pins are locked in place and the tripod is
at the correct height.
5. Move the IndustriPOD® to the desired location and splay legs
over area to required spread width.
6. Thread the leg tether strap through each IndustriPOD® leg foot
(Figure 3).
7. When the foot tether is threaded through all feet holes, join the
ends together to form a loop by feeding the tail end of the foot
tether sling through the buckle and tightening to ensure there
is no slack in the tether (Figure 4).
1
2
3
4
WARNING
Do not attempt to assemble the IndustriPOD® over an
open hole. Erect the IndustriPOD® away from voids
and edges and move it to the required location once
IndustriPOD® legs have been extended and locked into
place with leg pins.
