Fermax PBX CAM, User And Installation Manual

Page: 21 / 42

guard will lift up the line neither immediately (the button is not the first number
from code lock), or with delay (
parameter 53)
and after period given by
parameter 55
will dial the programmed phone number. The dialing number
differs by choice mode, which is set in the guard (
parameter 47
):
-
Day/night
mode = being the guard in Day mode, so it is always dialing
a number set in
parameter 1
, in Night mode, it is always dialing a
number set in
parameter 2
. The mode switchover is set in
parameters
45,46
.
- mode of second number group = first press – it always dials a number
set in
parameter 1
. By repeated press of the same button or detection
of busy tone after dialing the guard will select the number from the
second group (
parameter 2
). The next press of the same button again
selects a number of the first group, etc..……
If a visitor presses the button after guard lifting up, so the guard will hang
up for a period given by
parameter 54,
lift up the line and dial a new number.
The number choice is carried out both tone (DTMF), and pulse dialing
according to
parameter 41
setting.
The switch (
code lock
) can be controlled by first 10 buttons of guard. If
the visitor at door presses buttons in such combination that meet the
preprogrammed code (
parameters 32-34
) and the time among presses is not
bigger than the set point (
parameter 53
), then the guard will lift up and close
the corresponding switch (if set in m=1 or m=5 modes) to the period given by
parameter 36 event. 38
. Then it will hang up.
2.2.2 Guard with Keyboard
The guard with keyboard can also include
besides the keyboard up to 18 buttons of direct
dialing always behaving as to be mentioned in
Chapter 2.2.1 except the code lock. This one is
always situated on keyboard. After keyboard is
connected, the position, where the keyboard is
connected to, should be set (
parameter 48
).
The keyboard has two functional buttons –
key symbol
= once pressing the numerical
combination is considered as the combination for
control of the switches. The second button –
X symbol
= when pressing the
guard immediately will hang up.
The number selection on keyboard can be executed in two ways
(
parameter 49
):
- The incoming person is dialing number as to be done on phone – the
period among button presses should be lower than the value given by
parameter 53
. After this period the guard will lift up and dial the given
number.
- On buttons the incoming person is dialing a two-digit number (from 01
to 64), which represents the memory number, where the 16-digit