IP VarioBell
- installation and operating instructions
13
Connection of I
P-Fermax
The IP-Fermax contains the main board, optionally a camera board in
video version. The main board always comes with two push buttons on the
board. In the versions 1CP201IP and 1AP201IP both push buttons are used. The
modular Fermax Skyline series does not use any of these push buttons on the
main board. Only the Fermax Skyline expansion push button modules are used
in this case. Number of push buttons depends on the programming (consecutive
pressing of all push buttons in the selected order, more details are explained
later on). Up to 200 Fermax Skyline VDS/BUS2 push buttons and a Fermax
VDS/BUS2 numerical keypad can be connected to the main board. The main
board is equipped with two inputs (two door sensors or two exit buttons) and two
switches (relays). By using two programmable virtual relays you can control two
remote relays via http commands.
IP-Fermax main board
The main board is the same for all models of the IP-Fermax doorphone
and it differs only if the camera module is connected or not. There is always a
PoE module (according to the norm IEEE802.3af), connector for connecting
expansion modules, LED name card illumination, MicroSD card reader slot and
two switches (relays).
All functional and connected elements are marked with a number in a
red circle.
1.
CPU board (processor module)
2.
LED green
– powering of the doorphone is alright
3.
LED for checking network activity, green = connection of 100M LAN, yellow
= data transfer on LAN
4.
Slot for
MicroSD
card
– insert the card before switching on the doorphone
and do not pull it out during the entire operation of the doorphone!
5.
DIP switch
1
– always on (used for factory service only)
2
– off, when it is „on“ during the start, then
a default
IP address 192.168.1.250 and a default style are
set. Name is
admin
and password is
1234
. To show a video
stream, name is
video
and password
1234
(if required). The
operational position is
off.
6.
Connection of the UTP cable (Ethernet, LAN, network)
7.
Two
switches
(the middle clamp is common for both switches) for door
sensors or exit buttons (programmable)
8.
Connection of
cable from expansion modules
– 6-wire Fermax cable
9.
Terminal block of the switching contact of the
first relay
(NC= normally
closed, NO= normally open and COM= common, middle clamp/pin)
10.
Terminal block of the switching contact of the
second relay
(NO= normally
open and COM=comman, middle clamp/pin)
