IP VarioBell
- installation and operating instructions
10
Push button modules and keypad
The Fermax Skyline expanding push button
modules and a numeric keypad are the Fermax
Skyline VDS / BUS2 modules. The Fermax
Skyline expansion modules are connected with
the 6-core Fermax cable, which is always a part
of each Fermax Skyline expansion module.
The Fermax keypad is automatically detected in
the system, it does not need to be programmed.
Also it does not matter where the Fermax keypad
is connected.
The Fermax Skyline VDS / BUS2 push button
modules are connected in an independent order
of the numbering of the push buttons. The
Fermax Skyline push buttons numbering is
programmed in the usual Fermax way
– by
pressing the push buttons in the order from the
first to the last (see more below).
The principle of the connecting the expanding
modules
(C)
is shown in the figure.
Direction A
- (input) is the cable leading to the basic (voice) module.
Direction B
- (output) is the direction to the last module on the bus.
The position and the order of the expanding modules does not affect the
numbering of the push buttons. This is done in the programming sequence (so
called „push buttons mapping“) when everything is connected.
Numeric keypad
The numeric keypad is the original Fermax Skyline VDS/BUS2 module. It
is connected with the 6-core Fermax cable, which is always a part of each
Fermax Skyline expansion module.
The Fermax keypad is automatically detected in the system, it does not need to
be programmed. Also it does not matter where the Fermax keypad is connected.
Its presence in the system can be verified on the main
Status page in the programming web interface of the
doorphone. The keypad is detected with the first restart
after the keypad´s connection.
The selection is entered by consecutive pressing of the
number buttons,
the key B (or the Bell sign according
to the type of keypad)
must be pressed first to enter
the password. To hang up the call (to teminate the call),
press
the key A
and the doorphone will hang up at any
time. When entering an IP address for P2P direct dialling, use
the key B
as the
dot (.) in the IP address.
