INSTALLATION MODE (IM)
From the MAIN MENU, you can access all of the DUOX programmer's functions with
regards to the detection of already installed devices in a specific installation, analyse the
quality of digital frames in a specific point of the installation, verify the different commands
that are transmitted by any device on the installation, and the transmission to a PC of
these commands, transmitted for a determined period of time to be registered and then
sent to the factory if required in-depth analysis for some technical problem in the installation.
The available functions are:
- Component detection (telephones, relays, panels or guard units).
- Analysis of commands transmitted by the different devices.
- Measuring the quality (level) of the digital frames.
- Monitoring and registering a PC of the transmitted commands.
This is accessed via the main MENU as indicated in the following diagram and once the
programmer is connected to a BUS within the installation via the 3 way connector (see
the DESCRIPTION section).
A welcome message appears indicating the DUOX´s
programmer software version.
Access the DEVICE DETECTION menu
Press ON/OFF for 2 seconds to turn the programmer off.
Access the COMMAND ANALYSIS menu
Access the MEASURE FRAME LEVEL menu
Access the REGISTERING FRAMES ON A PC
menu
1. DETECTOR
DUOX ANALYZER
V.1.0
2. ANALYZER
4. SNIFFER PC
3. METER
OK
OK
OK
OK
ON
OFF
OK
ON
OFF