Ferm Industrial CDM1147P, Original Instructions Manual

Page: 7 / 132

7
EN
Charging the battery (with the charger)
Fig. C
• Take the battery (2) from the machine
• Turn the battery (2) to upside down position and
slide it onto the charger (5) as shown in Fig. C.
• Push the battery until it is fully pushed into the
slot.
• Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (6) will lighten up and show the
charger status.
LED indicators (6)
Fig.C
The charger has 2 LED indicators (6) which
indicate the status of the charging process:
Red LED
status:
Green LED
status:
Charger status
Off Off No power
On Off
Standby mode:
-No battery is inserted or,
-Battery inserted but charging has
finished more then 2 hours ago
Blinking Blinking Defective battery
On Blinking Battery charging in progress
On On
Battery charging finished, battery
fully charged
Blinking Off
Battery is too hot, charging
progress is on hold. Charging will
start automatically after the battery
has cooled down.
• Fully charging the battery may take up to 60
minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
• The battery can be stored or directly installed
on the machine.
Lithium-Ion cells can be stored for a long
period without losing much of their
charge. When the machine is not being
used over a longer period of time it is
best to store the battery in charged
condition.
Fitting and removing drills or screwdriver bits
Fig. A
Always remove the battery before
mounting an accessory.
The drill chuck (7) is suitable for drills and
screwdriver bits with round shaft as well as
hexagonal shaft.
• Hold the machine firmly with one hand
•
Open the drill chuck (7) by rotating the chuck
sleeve with your other hand in clockwise direction
until it is opened far enough for the bit to slide in.
• Insert the shaft of the drill or screwdriver bit
• Tighten the drill chuck again by firmly rotating
the chuck sleeve counterclockwise.
• Check if the bit is centered well by shortly
activating the machine´s on/off switch.
Adjusting the gears
Fig. A
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between
both positions, this will damage your
machine.
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (9) forward or
backwards. The number on the gear switch (9)
shows which position is chosen.
• Position 1: For slow drilling, large drilling
diameter or screw driving. The machine has
high power at a low speed.
• Position 2: For fast drilling or small drilling
diameter.
Adjusting the direction of rotation
Fig. A
• Set the direction switch (10) to position “

” in
order to drive screws or to use it for drilling.
• Set the direction switch (10) to position “

” in
order to remove screws
Switching the machine on and off
Fig. A
The on/off switch (11) is used for activating the
machine and adjusting rotation speed.
• Pressing the on/off switch (11) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.