28
To replace the glass you must remove the stainless steel staples that secure the glass, re-
moving the screws. The glass will be released making it possible to replace it. If there is a
space between the glass and the door, tighten the screws and, if it persists, very carefully
fold the staples to secure more tightly.
Any time you replace the glass it is necessary to replace the seal
, removing any
residue of the previous seal. The new seal must adhere on the entire perimeter. The seal
should not be adhered on the upper part as it may affect the “self-cleaning” system.
FERLUX ovens have a seal or cord on both doors. It is necessary to loosen the cord pe-
riodically for better adjustment. It is necessary to replaced it every time any form of wear
and tear is detected or on an annual basis. To replace it, all remains of adhesive and of
the old cord must be removed, using high-temperature adhesive in the installation of the
new cord.
4.3 Replacement of glass seal and door cord
Assembly of glass
5. PRINCIPAL CAUSES OF ERRORS AND SOLUTIONS
The following table describes the
anomalies that can be presented with greater frequency and the possible solutions
. When
this is indicated, it will be necessary for a professional or Technical Assistance Service authorised by
FERLUX Chimeneas y Barba
-
coas
to conduct the checks described.
Problem
Cause
Solution
Fire too low or won’t catch
Damp or green firewood
Damp, green or very young firewood contains an ex
-
cessive quantity of water which results in much of the
heat energy evaporating with the water. The solution is
to
use quality firewood
or fuel in accordance with the
instructions in section 3.1.
Firewood too big
To initiate combustion, as well as the “fire lighter packs”
We recommend that you use
small logs with a greater
surface exposed to the flame and easily consumed.
Poor quality or unsuitable
firewood
Not all types of wood offer the same performance. For
optimal conditions, We recommend that you use the fu-
els indicated in section 3.1.
Insufficient air
Oxygen from the air is crucial for combustion. Ensure
that apparatus has
an open air vent (primary and/or
glass)
, in accordance with the instructions in section
3.2.
To facilitate the start of combustion, open the
door some 3 or 4 cm
until the glass is heated. Simi-
larly, it is also possible for some entry to be obstructed.
Insufficient draught
Check that the
smoke extractor flue
is not obstructed,
that its shape is suitable as described in section 2.2 and
arrange de-sooting if necessary.
TAS
For any long period
without using the device
, such as over the summer season, We recommend that you undertake a thorough
cleaning of the fireplace and de-sooting of the chimney. It is also recommended to
close the different air vents
(primary, glass and
channels)
After being stopped for a long period of time, it is necessary to check that the air vents and the smoke extractor are not blocked, as
well as the grilles of the turbines.
4.2 Seasonal or lengthy non-use of the device
