LED and Connectors description
ACT (green)
is flashing during wireless traffic.
POWER (red)
is steady when the device is connected to power plug.
LINK (yellow)
is flashing during LAN 10BaseT traffic and steady when the cable is
plugged into the ethernet connector RJ45.
RJ45 Connector:
to connect the Twisted Pair ethernet cable for the purpose of con-
necting with Power Over Ethernet HUB (the cable is not included, but the power
supply is included).
N/Female Connector:
to connect to the external ISM antenna (not included, see
Ferimex IT offerings of a variety of antennas).
Outdoor Client installation
The installation kit is designed primarily for installation with an ISM antenna holder,
but can be also used separately with a console.
With a console: a special holder is recommended for console operation. Ask
Ferimex for this holder: [email protected]. Two screws with the holder is all you
need for the installation. Tighten the screws in the front panel – only then is the
Outdoor Client weatherproof.
With an ISM antenna holder: Two screws in the horizontal antenna holder are
directly for the Outdoor Client back panel holes. Antenna elevation and azimuth
are set together with the device.
Antenna connection
The RF interface on the Outdoor Client is an N/female type connector. You need to
connect an antenna cable with N/male type connector. You don‘t need any pigtails for
the connection.
Attention!
The device is a high-frequency microwave generator. Don’t use the device
without an antenna attached to it. Do not touch any connector during operation. Use
only a correct antenna type.
Power connection
The Outdoor Client is powered with a Power Over Ethernet module (HUB), which is
an AC/DC converter (48V DC). Ethernet UTP cable is used for power feeding.
Maximum distance between POE HUB and Outdoor Client is 100 meters. Use 1:1 UTP
cable. Connect the cable to the connector P-Lan-Out POE.
4
OUTDOOR CLIENT
