www.ferimex.com
Put the cable (1) through the front of the
antenna grid and out the back of the metal
tube holder (3), but do not put the metal
tube (2) into the metal tube holder yet.
Fasten the elevation holder (5) to the metal
tube holder (3) using two bolts (8), adding
the washer (14), split washer (13), and the
nut (11). Then insert the metal tube into the
metal tube holder (3) all the way until it hits
the bolt (8). The focal length will then be
correct.
IMPORTANT:
The flat side of the plastic receiver must be
oriented parallel to the ribs of the antenna
grid. The antenna will NOT function if the
receiver is oriented 90 degrees from the
metal ribs!
In the hole in the metal tube holder (3) put
a bolt (10) and tighten, so that the metal
tube/receiver combination is fixed and
cannot move.
Put the four bolts (9) through the holes in
the elevation holder (5), and then add
onto the bolts the two sharks (6), the four
washers (14), four split washers (13),
and the four nuts (11). This assembly is for
mounting onto poles or consoles.
Obr. 4
Obr. 5
Obr. 6
1
8
5
3
10
9
6
9
3
2
14 13 11
5
14 13 11
