FENIX IMVICO
TK51/IF9000 OPERATION MANUAL
70/82
____________________________________________________________________
APPENDIX C – RECOVERY FROM AUTOCUTTER ERROR
____________________________________________________________________
•
If an object, such as a push pin or paper clip, drops in the autocutter and causes the
autocutter to lock up, the printer will enter error state.
If it is not a critical problem, the autocutter will return automatically to its home
position.
If the autocutter can not return to its home position by itself, turn the printer off. Insert
a Phillips screwdriver through the slot as shown in figure C.1
and into the screw in
the worm gear of the motor axis. Then, turn the screw until blade retreats.
•
If you cannot rotate the motor gear, rotate it in the reverse direction to loosen it; then
press the paper feed button. Open the platen unit (see figure a), remove the jammed
paper, and reinstall the paper roll. Then close the platen unit.
Fig.C.1-
Printer mechanism. Lateral view.
Insert Phillips
screwdriver and
turn it till blade
retreats
