Fenix Imvico TK51 Series, Operation Manual

Page: 61 / 82

FENIX IMVICO
TK51/IF9000 OPERATION MANUAL
61/82
FS p n m
[Name] Print NV bit image
[Format] ASCII FS p
n m
Hex 1C 70 n m
Decimal 28 112 n m
[Range] n = <01>H
<30>H
≤
m
≤
<33>H
[Description]Prints a NV bit image n using the mode specified by m .
m Mode
Vertical
Dot
Density
Horizontal
Dot
Density
<30>H Normal 203.2 dpi 203.2 dpi
<31>H Double-width 203.2 dpi 101.6 dpi
<32>H Double-height 101.6 dpi 203.2 dpi
<33>H Quadruple 101.6 dpi 101.6 dpi
[dpi: dots per 25.4 mm]
•
n is the number of the NV bit image (always 1).
•
m specifies the bit image mode.
[Notes]
•
NV bit image means a bit image which is defined in a non-volatile
memory by FS q and printed by FS p .
•
This command is not effective when the specified NV bit image has not
been defined.
•
This command is effective only when there is no data in the print buffer.
•
This command is not affected by print modes (emphasized, double-
strike, underline, character size, white/black reverse printing, etc.).
•
If the printing area width set by
GS L
for the NV bit image is less than
one vertical line, the following processing is performed only on the line
in question. However, in NV bit image mode, one vertical line means 1
dot in normal mode (
m =30H) and in double-height mode ( m =31H), and
it means 2 dots in double-width mode ( m =32H) and in quadruple mode
( m =33H).
•
If the printing area width cannot be extended by one line vertically, the
left margin is reduced to accommodate one line vertically.
•
The printing area width is extended to the right in NV bit image mode
up to one line vertically. In this case, printing does not exceed the
printable area.
•
If the downloaded bit-image to be printed exceeds one line, the excess
data is not printed.
•
After printing the bit image, this command sets the print position to the
beginning of the line and processes the data that follows as normal
data.
[Reference] FS q, GS v 0