Warning!
Do not overtighten the hex bolts on the light bar. Doing so may cause the light bar to bow downward.
Figure D
Figure F
Electrical Installation
Power Cable Wiring:
1.) Install a 40Amp Fuse (customer supplied) to the end of the Red, 8 AWG wire of the
light bar power wire harness assembly. Do not use a circuit breaker or fusible link. Do not
insert the fuse until the opposite end of the fuse holder is connected to the vehicle battery.
2.) Connect the opposite end of the fuse to the 12V + terminal of the battery. Do not use
more than 1 foot of wire between the fuse and the battery terminal to ensure wire protec-
tion.
3.) Connect the Black, 8 AWG wire to the factory chassis ground.
Function Cable Wiring:
1.) Route the Function Cable wire to the control equipment.
2.) Wire function cables to switches, depending on functions to be implemented in vehicle.
Warning: All Customer supplied wires connecting to 12V + or 12V- must be sized to supply
at least 100% of the maximum current and properly fused at the power source with the cor-
rectly rated fuse. Avoid routing wires in the deployment area of the vehicle air bag or any
other potentially hazardous locations.
WIRING DIAGRAM
www.Feniex.com
©Feniex Industries, Inc.
