To service or replace a LED module:
1.) Remove the top cover by removing the metric M5 Phillips Screw on the center cover
To gain access to the alley or corner modules the aluminum end cap must be removed.
To gain access to the end cap, the center top cover must be first removed.
2.) Each module is supported by 2 metric M3 x7 Phillips Screw.
3.) To remove a module, unfasten both screws from the back of the module ( as shown in Figure B).
4.) Slide out the 2 plastic end caps on each side of the module ( as shown in Figure B).
5.) Disconnect the male connector from the wire assembly extruding from the controller.
6.) Connect the male connector of the replacement module to the same port on the controller.
7.) Place the module in the frame and fasten both screws from step 3 to the back of the module.
8.) Slide the plastic clips back into the frame on each side of the module.
9.) Fasten the top cover with the hardware removed during Step 1.
Figure A
Figure B
LED Module
Top Cover
M5 Phillips Screw
Clip
M3x7 Screw
www.Feniex.com
©Feniex Industries, Inc.
SERVICE DIAGRAM
