Adjusting Height
Depending on the height of the vehicle, the feet of the bar will need to be adjusted for the required height and angle of
the vehicle. To adjust the height:
1.) Determine the location for the vehicle for the light bar and check that no equipment will be damaged when drilling
holes in the vechile to mount the light bar.
2.)Unfasten the hex bolt located on the side of the feet (as shown above) to adjust the height of the bar. Most sedans
require the feet at the maximum height, while flat surface vehicles, such as SUVS require more adjustment to meet the
required height.
3.)Once the required height is met, fasten the hex bolt to lock the height on the feet in position.
4.)A rubber grommet is provided to function as a cushioning barrier between the roof and the metal bracket.
Installing the Vehicle Specific Hook Bracket
1.) Remove the 3” hex bolt which is pre-inserted in the light bar feet.
2.)Using the hook bracket drill and secure the bracket to the vehicle using the two pilot holes on the bottom
of the bracket.
3.)Ensure that the vehicle’s door will close without any interference.
4.)Tighten the vehicle specific bracket by reattaching the hex bolt to secure the hook bracket to the light bar
feet.
5.)Secure and tighten the bracket on each side until the bar is snugly mounted.
6.) Once secure, drill a one inch hole to route the harness assembly through the vehicle and then seal the
hole with a silicone adhesive.
Figure C
Figure D
Figure E
MOUNTING DIAGRAM
