Tap tempo for time-based effects and Tone Master PRO’s onboard tuner are easily accessed and controlled using the TAP/TUNER
footswitch at lower right, and also manually on the touchscreen.
29
TAP TEMPO
Delay and modulation effects can be synched to an individual preset tempo or globally for all presets by assigning the preferred rhythmic
subdivision when editing the effect. Delay and modulation effects only respond to tap tempo control if specifically assigned to do so; this is
done by using the TAP DIV parameter (in the edit screen for each effect) that works together with current tempo to set a beat-synched delay
time or modulation speed.
The LED ring around the tap footswitch at lower right will flash at the current tempo. To enter a new tempo by hand or foot, tap the
TAP/TUNER footswitch at least twice at the desired rate. The tempo is displayed in BPM in the scribble strip above the footswitch, and the
touchscreen will change to a BPM gradient view of the tempo for three seconds, during which the tempo can also be adjusted by swiping a
finger up and down the gradient. The LED then flashes at the adjusted tempo.
Tap tempo adjustments are saved with the preset by default and do not apply to other presets; however, tap tempo changes can be config-
ured as global tempo settings that apply to all presets; this is done in the Footswitch section of Global Settings.
• Alternately, the touchscreen will show a gradient for three seconds; slide
a finger up or down the gradient to set a new BPM value; fine tune by
touching plus (+) and minus (-) symbols below the gradient.
• Press footswitch at least two times to set BPM.
• Press/hold footswitch for two seconds to access tuner.
TAP 100 BPM
HOLD: TUNER
