Fender Super Champ-XD, Owner'S Manual

Page: 6 / 20

f e n d e r . c o m
The Super-Champ® of the early 1980s was a real eye opener in its
day—a full-featured tube guitar amp, with a surprising amount of
power, in a tiny package. The Super-Champ® XD amplifier takes that
format into a new era by combining a real tube amp with versatile
digital voicing and effects. Rehearsals, recording sessions, and even
small gigs are a joy to play with the Fender Super-Champ.
Thank you for choosing Fender®
World's most popular instrument amplifiers—since 1946.
• 15 Watts into 8 ohms
• Digital Signal Processing
• 16 Effects “F/X” settings
• 16 Amplifier “VOICE” settings
• 1 Classic Fender® clean tone (Channel-1)
• 2 Channels—independent settings and sounds
• Footswitch (optional)—enables remote channel switching and
effects bypass
• Line Output—for recording or sound reinforcement
A . INPUT— Plug your guitar in here.
B . VOLUME 1—
Adjusts the loudness of Channel-1, which is voiced
for Blackface™ clean tone.
C . CHANNEL SELECT— Press to switch channels (see Footswitch
{Q}):
CH 1 CH 2
D . GAIN—
Controls preamp volume for Channel-2. Also controls
signal distortion, except when VOICE 16 {G} is selected.
E . CHANNEL LED—
Indicates the active channel:
CH 1 CH 2
F . VOLUME 2— Use to set the loudness of Channel-2 after
adjusting GAIN {D}.
G . VOICE—
Select one of 16 amplifier voicings for Channel-2 (see
next page).
NOTE: Use the extreme flexibility of the Voice knob wisely!
Treble harshness or boomy bass tones can be avoided by using
the right guitar settings and playing style for a particular amp
voicing.
H . TREBLE/BASS—
Adjusts the high- and low-frequency tone
characteristics of both channels.
I . FX LEVEL—
Adjusts the intensity of the active effect.
J . FX SELECT— Selects the active effect (see next page).
K . POWER JEWEL—
Indicates when the unit is on.
rear panel
L . POWER CORD SOCKET— Connect to a grounded outlet using
the included power cord in accordance with the voltage and
frequency ratings specified on the rear panel of your amplifier.
M . POWER SWITCH— Switches the amplifier ON–OFF.
N . FUSE—
Protects the unit in case of electrical faults. Replace
only with the type and rating specified on the rear panel of
your amplifier.
O . SPEAKER OUT— Connection for the internal speaker or an
external speaker (8Ω/25W minimum).
Use only a standard 1/4" mono plug.
P . LINE OUT—
Connect your recording or sound reinforcement
equipment here.
Use only a standard 1/4" mono
plug.
Q . FOOTSWITCH— Connect the optional 2-
button footswitch here with the supplied
cable to enable remote channel selection
and effects bypass. NOTE: The CHANNEL SELECT {C} button
is disabled when the footswitch is connected. If you need a
longer footswitch cable, use (unshielded) speaker cable rather
than (shielded) guitar cable.
Super-champ Xd amplifier
front panel
F3A L
250V
F3A L
250V