User’s Manual S40-R
FEMA ELECTRÓNICA - Page 10
A
B
You may need to access the inside of the instrument to insert
additional modules. Use a flat screwdriver to unlock the upper
clips marked with “A”. Then unlock the lower clips marked
with “B” and move out the front filter. Let the inside of the
instrument slide out of the housing.
To reinsert the instrument make sure that all modules are
correctly connected to the pins on the display module. Place
all the set into the housing, assuring that the modules cor-
rectly fit into the internal guiding slides of the housing. Once
introduced, place again the front filter by clipping first the
upper clips “A” and then the lower clips “B”.
Important - If your instrument was delivered with the IP65 front
seal option, accessing the inside of the instrument will perma-
nently break the IP65 seal on the areas of clips “A” and “B”.
1.13 Accessing the instrument
Configuration (Conf) -
Informs the configured input signal
range (4/20mA, 0/10Vdc, ...), and the values for input low
“ILo”, display low “dLo”, input high “IhI” and display high “dhI”.
Maximum (MAX) -
Value of the maximum display.
Minimum (MIn) -
Value of the minimum display
AlarmX (ALX) -
Configuration of alarm X. The sequence of
information shows if the alarm is being managed (“On/Off”),
the alarm type (“Max/Min”), the setpoint, the hysteresis value,
the activation delay and the value of setpoint2 (“Off” or the
setpoint2 value).
OptionX (OptX) -
Type of module installed. If there is no
module shows “nonE”.
Measure (MEAS)-
Multimeter function. Shows the value of
the input signal without scaling. This is the real value the
instrument is receiving on terminals, in Vdc or mA.
1.12.1 Information menu
1.12 Information menu
Configuration
See menu for Alarm1
Alarm1
Maximum
Minimum
Memory of minimum
Option1
Option installed
Option2
Option installed
Measure
Range (Rat.,Pot<5K, Pot<5M)
Input Low
Display Low
Input High
Display High
Memory of maximum
“On / Off”
“Max” / “Min”
Setpoint
Hysteresis
Delay
Setpoint2
Counts
Seconds
Second
setpoint
Range”
Measured value
Press UP button to enter Information Menu