Fellowes Standard Morgana FRN-6, Service Manual

Page: 10 / 67

R O T A R Y
PAGE 8
S E R V I C E
Friction Feed .............................................................. Fig 2.11
Two Cap Head Bolts Each Side
Grub Screw
Gears Inside Housing Pull Housings Together To Release Pins
Section 2 FRICTION FEED
2.1 ...... Friction Feed Drive Shaft
The friction feed drive shaft is removed after unscrewing the four
cap head bolts as shown in Fig. 2.11. The bearing housings are
located on dowel pins and must be pulled inwards as shown to
release them but take care not to lose the idler gear and washer
from inside the clutch side housing.
To replace the friction feed tyre, the friction feed shaft is
dismantled as follows:- (See Fig. 2.21)
-Remove the grub screw from the drive hub and rotate the drive
hub to align the holes in both hub & shaft so that a 2.5mm hexagon
wrench / allen key will pass through both. This will enable you to
hold the shaft whilst releasing the M6 nut at the end, (using a
10mm socket wrench) and withdraw all components from the
shaft.
Note:....... During dismantling and certainly before re-assembly,
ensure that all components are kept clean and handled
carefully to avoid damage. The drive has to be sensitive
to all stocks - particularly lightweight NCR -& it's
sensitivity will be impaired if the components are