3
-JNJUFE 8BSSBOUZ 'FMMPXFT *OD i'FMMPXFTw XBSSBOUT UIF QBSUT PG UIF NBDIJOF UP CF GSFF PG
defects in material and workmanship and provides service and support for 2 years from the date of
QVSDIBTFCZUIFPSJHJOBMDPOTVNFS'FMMPXFTXBSSBOUTUIFDVUUJOHCMBEFTPGUIFNBDIJOFUPCFGSFF
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
SFNFEZXJMMCFSFQBJSPSSFQMBDFNFOUBU'FMMPXFTPQUJPOBOEFYQFOTFPGUIFEFGFDUJWFQBSU5IJT
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
VOBVUIPSJ[FESFQBJS'FMMPXFTSFTFSWFTUIFSJHIUUPDIBSHFUIFDPOTVNFSTGPSBOZBEEJUJPOBMDPTUT
JODVSSFECZ'FMMPXFTUPQSPWJEFQBSUTPSTFSWJDFTPVUTJEFPGUIFDPVOUSZXIFSFUIFTISFEEFSJTJOJUJBMMZ
TPMECZBOBVUIPSJ[FESFTFMMFS"/:*.1-*&%8"33"/5:*/$-6%*/(5)"50'.&3$)"/5"#*-*5:
03'*5/&44'03"1"35*$6-"3163104&*4)&3&#:-*.*5&%*/%63"5*0/505)&"113013*"5&
8"33"/5:1&3*0%4&5'035)"#07&*OOPFWFOUTIBMM'FMMPXFTCFMJBCMFGPSBOZDPOTFRVFOUJBM
PS JODJEFOUBM EBNBHFT BUUSJCVUBCMF UP UIJT QSPEVDU 5IJT XBSSBOUZ HJWFT ZPV TQFDJGJD MFHBM SJHIUT
5IFEVSBUJPOUFSNTBOEDPOEJUJPOTPGUIJTXBSSBOUZBSFWBMJEXPSMEXJEFFYDFQUXIFSFEJGGFSFOU
MJNJUBUJPOTSFTUSJDUJPOTPSDPOEJUJPOTNBZCFSFRVJSFECZMPDBMMBX'PSNPSFEFUBJMTPSUPPCUBJO
service under this warranty, please contact us or your dealer.
LIMITED PRODUCT WARRANTY
Alternate slowly back and forth
Set to Reverse (R)
for 2-3 seconds
4FUUP0GG 0
and unplug
Gently pull uncut
paper from paper
entry. Plug in
Shredder doesn’t start:
Make sure head is on basket correctly
Wait 30 minutes for motor to cool down
Remove and empty basket
TROUBLESHOOTING
5
1
4
3
2
6
Continuous operation:
Up to 3 minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3 minutes will trigger a
30-minute cool down period.
BASIC SHREDDING OPERATION
PAPER OR CD/CARD
When finished shredding
TFUUP0''
)
4FUUP"VUP0O *
Plug in and put
disconnect power
switch in ON (I) position
4FUUP"VUP0O
(I) and resume
shredding
PAPER JAM
1
2
3
5
1
4
'FFEQBQFSTUSBJHIUJOUP
paper entry and release
'FFEJOUPDBSE$%
entry and release
or
PRODUCT MAINTENANCE
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
.
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEB
machine may experience diminished sheet capacity, intrusive noise when
TISFEEJOHBOEDPVMEVMUJNBUFMZTUPQSVOOJOH5PBWPJEUIFTFQSPCMFNTXF
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
5VSOPGGBOEVOQMVH
shredder
Locate Auto-start
infrared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
* Apply oil
across entry
4FUUP0GG 0
Set to Reverse (R)
2-3 seconds
2
1
3
3
1
2
4