14
WORLDWIDE WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material
and workmanship for 2 years from the date of purchase by the original
consumer. If any part is found to be defective during warranty period,
your sole and exclusive remedy will be repair or replacement, at
Fellowes’ option and expense, of the defective part. This warranty does
not apply in cases of abuse, mishandling or unauthorised repair. Any im-
plied warranty, including that of merchantability or fitness for particular
purpose, is hereby limited in duration to the appropriate warranty period
set forth above. In no event shall Fellowes be liable for any consequential
damages attributable to this product. This warranty gives you specific le-
gal rights. You may have other legal rights that vary from this warranty.
The duration, terms and conditions of this warranty are valid worldwide,
except where different limitations, restrictions or conditions may be
required by local law. For more details or to obtain services under this
warranty, please contact Fellowes or your dealer.
TROUBLESHOOTING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to
edge.
Partial holes
Damaged hole edges
Cause
Edge guide not set
Blockage
Debris are stuck below dies.
Sheets not correctly aligned to punch
pattern.
Possibly overloading the machine
Solution
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper
entry
Take stiff cardboard and slide into the paper entry. Move
the cardboard sideways to release any stray clippings into
the waste tray
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
ENGLISH
13
BINDING A DOCUMENT
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by first removing the old metal coil. Correct document as necessary, then rebind as
described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located in the back of the machine. For best results empty the tray regularly.
Collate the document. Load the
coil on to the first 3 holes.
4
Use the binding pliers to cut and
fold the end of the metal coil. Clip
off the excess coil.
6
Turn the document around.
7
Clip off the excess coil.
8
Punch sheets in small batches
so as not to overload the
machine or the user.
2
MÁX 12
(80gsm)
Punch front and back covers
first.
Switch the inserting roller on.
Hold the document in both hands,
with the metal coil on the right
side. Touch the metal coil against
the inserting roller to bind the
document.
3
5
1
Metal50R_409581_RevB_3L_041317.indd 13-14
4/13/17 3:33 PM
