P
age
54
[email protected]
www.FELIXprinters.com
User manual FELIX 3.0 3d printer
The following checks are endurance tests which are done before assembled printers are released to our
customers. For assembled printers the printed parts generated are supplied with the printer.
The following checks are required for CE safety.
No
Printing checks
Check
20.
All I/O working properly
21.
00_test_thinwall_v3_export.gcode,
print small test with
extruder 1
22.
02b_print_assy_display_unit_F3_0.gcode,
print display unit case with
extruder 1
23.
03_print_assy_felix_single_extruder_V3.gcode,
print accessory set part 1,
with
extruder 1
24.
NOTE:
Only print for single extruder printer.
05_Extruder_cover_single_extruder_V2.gcode,
with
extruder 1
NOTE: Following prints are only needed for Dual extruder printer
25.
00_test_thinwall_v3_export.gcode ,
print small test with
extruder 1
26.
06_cover_dual_extruder_V7.gcode,
with
extruder 2
27.
NOTE: Before printing this, make sure extruder cover is already mounted.
01_calibration_dual_extruder.gcode,
calibrate distance between nozzles
28.
04_print_assy_felix_accessoires_dual_extruder.gcode,
print accessory set part 2
No
CE safety checks
Check
29.
Heat shield mounted onto extruder.
30.
Heat warning signs placed according to manual
31.
Usage of gloves warning signs placed according to manual
32.
Pinching danger warning signs placed according to manual
33.
Handle is mounted properly
34.
Check if damping feet are placed underneath printer
35.
All four bolts tight on electronics enclosure?
36.
CE label is mounted according to instructions?
37.
Serial number sticker is mounted onto CE sticker?
38.
Checklist signed by authorized person.
