www.felixprinters.com
Page
56
of
65
Belts/Pulley’s
Usually when perimeters ofexperiencing bad print quality, this can mean the followingMake sure the pulley’s are tightened.
1: Pulley’s are not tightened enough
2: Belt tension is not high enough.
Hot-end
Check that the hot-end is fixed in the extruder carriage. If not, the prints will come out ugly.
15.3
Software.
High print speeds is nice, but you will suffer print quality. To have a good compromise between speed and quality, an infill speed of
80mm/s is a good start, then take the perimeter speed at 30 or 40mm/s.
