Quick Start Guide FELIX Pro 3
Page
22
1.
Pull off edge connector of corresponding print head, do NOT pull the wires.
2.
Open the cover in front.
3.
Rotate slightly to right
4.
and Then pull out print-head
5.
Reverse the assembly of the hot-end into the extruder assembly. Do not forget to close the lid.
IMPORTANT: Ensure the hot-end wires make the bend as shown in picture above, it should not touch
the bed.
6.
Please do the following two extruder calibrations, if you wish to properly print with dual head.
-
Z-height calibration
-
XY calibration
2
4
3
1
