Felder FB 540, User Manual

Page: 28 / 48

28
!
"
#
$
"
Bandsaw
FB 540/640/740/840/940
7.4.5 Direction of cut and parallelism
7.4.4 table pad and wooden pad for dust extraction
The machine is equipped with a plastic table pad. The
holes in this pad facilitate the task of extracting dust. The
height of the table padding can be adjusted exactly to
table level with the 4 adjusting screws in the table open-
ing. Machines with a wheel diameter of up to 600 mm
only have one dust extraction port.
Machines with a larger wheel diameter, have a second
dust extraction port, located at the front of the machine,
below the working table. To maintain the extraction ca-
pacity, change the wooden pad if the cutting gap is get-
ting too large.
Fig. 22: Table insert and Wooden pad
!
Wooden pad
"
Dust extraction holes
#
Vacuum connection
$
Clamping screws
If the cut, using the longitudinal stop, is still not parallel,
the following are possible causes:
• Incorrect saw belt grinding and set
• Insufficient saw belt tension
• Incorrect longitudinal stop setting in relation to the
saw belt. To adjust the parallelism, loosen the 2
clamping screws, readjust the parallelism and tighten
the clamping screw.
Operation