OBID i-scan
®
Installation
ID ISC.ANT1400/760-A/B/C
FEIG ELECTRONIC GmbH
Page 9 of 50
M50700-4e-ID-B.doc
3.2 Mounting preparation
For assembly the antenna must be carefully unpacked and disassembled into its main
components. This is done as described in the following steps:
1. Place the packed antenna on the floor with the top side facing up. Carefully open the box and
remove the side cover plates. Then remove the antenna and at last the side panels.
Fig. 2: Antenna in its packaging
Fig. 2a: Side panels in its packaging
2. Carefully put the antenna down again and remove the two fastening brackets in the antenna
foot (Fig. 3). Disconnect the antenna cable from the Multiplexer (Type C) or Power Splitter
(Type A) and disassemble the cable for the alarm light in the antenna foot. Then the antenna
body can be separated from the antenna foot.
Step 1
Step 2
Fig. 3: Separating antenna body from antenna foot
Fastening brackets
