IDENTIFICATION
ID ECCO Smart HF-BLE
Operation
USER GUIDE
Page 9 of 25
5 Operation
Operation
5.1 Charging the Battery
Before the first operation, the battery should be fully charged by using the included USB charging cable. As
long as the battery is charging the yellow LED will light solid yellow. After the battery is fully charged the
yellow LED turns off. A full recharge of the battery takes approx. 3 to 4 hours.
To charge the battery via USB follow the instructions below:
Remove the USB protection clip from the device.
Connect the device to the USB port of a computer or to the USB power adapter (accessories).
As long as the battery is charging, the yellow LED lights solid yellow.
After the battery is fully charged the yellow LED turns off.
If a low state of charge of the battery is reached, the red LED flashes briefly every 2 seconds.
At not used devices, the reader switch to sleep mode. A full charged battery will be discharged after about
80- 90 days
5.2 Switch On/Off
To turn ON the Reader press Power key 8 for minimum 3 seconds. Pressing this key for 3 seconds, again,
turns the unit OFF.
Fig. 2: Switch ON/OFF
